====== HDHomeRun PRIME ====== The HDHomeRun PRIME is used for US cable TV, using CableCARD. {{:prime_front_with_roundel.png?direct&300|HDHR3-CC Front}}{{:prime_back.png?direct&300|HDHR3-CC Back}} ^ Model number | HDHR3-CC | ^ Signal type | US Cable TV & QAM64/256 | ^ Tuners | 3 | ^ Works_with_DVR | Yes | ^ Size | | ^ Ports | Coaxial-in, USB (for Tuning Adapter), Ethernet (1000BASE-T), Power, M-card (CableCARD) slot | ^ Power supply | 5Volt 2.5Amp regulated power adapter (higher Amp rating ok) \\ 2.1mm ID / 5.5mm OD plug, 9-10mm depth, center positive \\ Max 5.25V @ no-load \\ Min 4.75V @ 2.5A \\ Noise <= 100mVp-p \\ \\ Normal operating current is approximately 1.25A with a CableCARD present and 3 tuners streaming. \\ \\ For testing purposes a 5V 2A power adapter can be used as long as the USB port is not powering any bus-powered devices. | ===== Other PRIMEs ===== In addition to the more common HDHomeRun PRIME HDHR3-CC: * HDHR3-6CC-3x2 - a dual unit that uses two CableCARDs. * HDHR5-6CC (HDHomeRun PRIME 6) - a new single-CableCARD six tuner PRIME that is currently in development. ===== Updating firmware====== [[:update|See: Updating firmware]] ===== FAQ ===== [[:PRIME:FAQ|See: PRIME:FAQ]] ===== Diagnostics ===== [[:PRIME:Diagnostics|See: PRIME:Diagnostics]] ===== DRM-restricted channels ===== [[drm|Troubleshooting:Requirements to playback drm-restricted channels]] ===== LED status ===== * Left LED: Power/link: Green = Ethernet link, flashing = searching for DHCP, red = no Ethernet link. * 2nd LED: Cablecard: Green = CableCARD present, flashing = card present but not ready (authentication in progress or no RF feed). * Tuner LEDs (3) (only on early models): Green = streaming video, flashing = reserved for use but not streaming. {{tag>prime hardware}}