Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
extend [2019/09/15 03:27] neds |
extend [2022/11/10 07:18] neds |
||
---|---|---|---|
Line 22: | Line 22: | ||
^ Size | | | ^ Size | | | ||
^ Ports | Antenna, Ethernet (100baseTX), Power | | ^ Ports | Antenna, Ethernet (100baseTX), Power | | ||
- | ^ Power supply | <wrapper> 12V 1.5A regulated power adapter (higher A rating ok) \\ 1.3mm ID / 3.4mm OD plug, 9.5mm depth, center positive \\ Noise Noise <= 150mVp-p 150mVp-p </wrapper> | | + | ^ Power supply | <wrapper> 12Volt 1.5Amp regulated power adapter (higher Amp rating ok) \\ 1.3mm ID / 3.4mm OD plug, 9.5mm depth, center positive \\ Noise <= 150mVp-p</wrapper> | |
</WRAP> | </WRAP> | ||
+ | ===== Updating firmware====== | ||
+ | <WRAP indent> | ||
+ | |||
+ | <btn type="success" size="lg" icon="fa fa-chevron-right">[[:update|See: Updating firmware]]</btn> | ||
+ | |||
+ | </WRAP> | ||
===== Transcode Configuration ===== | ===== Transcode Configuration ===== | ||
<WRAP indent> | <WRAP indent> | ||
- | + | {{ :extend_transcode1.png?direct&400|}} | |
- | Go to the device webpage (via http://my.hdhomerun.com) Click on your HDHomeRun Extend's device ID, then click on **Transcode Configuration**. | + | - Go to the device webpage: http://hdhomerun.local (or replace "hdhomerun" with the device ID), or use the local IP address of the unit. |
+ | - Then click on **Transcode Configuration**. | ||
==== Default Transcode Profile ==== | ==== Default Transcode Profile ==== |