Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
extend [2019/11/03 03:20] neds |
extend [2022/11/10 07:18] neds |
||
|---|---|---|---|
| Line 22: | Line 22: | ||
| ^ Size | | | ^ Size | | | ||
| ^ Ports | Antenna, Ethernet (100baseTX), Power | | ^ Ports | Antenna, Ethernet (100baseTX), Power | | ||
| - | ^ Power supply | <wrapper> 12V 1.5A regulated power adapter (higher A rating ok) \\ 1.3mm ID / 3.4mm OD plug, 9.5mm depth, center positive \\ Max 5.25V @ no-load \\ Min 4.75V @ 1A \\ Noise Noise <= 150mVp-p</wrapper> | | + | ^ Power supply | <wrapper> 12Volt 1.5Amp regulated power adapter (higher Amp rating ok) \\ 1.3mm ID / 3.4mm OD plug, 9.5mm depth, center positive \\ Noise <= 150mVp-p</wrapper> | |
| </WRAP> | </WRAP> | ||
| + | ===== Updating firmware====== | ||
| + | <WRAP indent> | ||
| + | |||
| + | <btn type="success" size="lg" icon="fa fa-chevron-right">[[:update|See: Updating firmware]]</btn> | ||
| + | |||
| + | </WRAP> | ||
| ===== Transcode Configuration ===== | ===== Transcode Configuration ===== | ||
| <WRAP indent> | <WRAP indent> | ||
| - | + | {{ :extend_transcode1.png?direct&400|}} | |
| - | Go to the device webpage (via http://my.hdhomerun.com) Click on your HDHomeRun Extend's device ID, then click on **Transcode Configuration**. | + | - Go to the device webpage: http://hdhomerun.local (or replace "hdhomerun" with the device ID), or use the local IP address of the unit. |
| + | - Then click on **Transcode Configuration**. | ||
| ==== Default Transcode Profile ==== | ==== Default Transcode Profile ==== | ||