Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
dvr:nas:synology [2020/06/24 02:57] neds |
dvr:nas:synology [2020/06/24 02:59] neds [4. Auto-start DVR when NAS boots up] |
||
|---|---|---|---|
| Line 117: | Line 117: | ||
| - Click on the "Task Settings" tab | - Click on the "Task Settings" tab | ||
| - Under "Run command" paste the following: <code>#!/bin/bash | - Under "Run command" paste the following: <code>#!/bin/bash | ||
| - | /volume1/HDHomeRun/hdhomerun_record start --conf /volume1/HDHomeRun/hdhomerun.conf</code> | + | /volume1/HDHomeRun/hdhomerun_record start --conf /volume1/HDHomeRun/hdhomerun.conf</code> <wrap tip>If necessary, change "volume1" to the volume pool that you are using on your Synology NAS.</wrap> |
| - Click "Okay" and make sure your new task is enabled, and click "Save" if the button is not grayed out. | - Click "Okay" and make sure your new task is enabled, and click "Save" if the button is not grayed out. | ||
| - and you're done! | - and you're done! | ||