Differences

This shows you the differences between two versions of the page.

--- connect [2019/06/20 02:25] – [No/few channels found in channel scan] neds
+++ connect [2026/05/14 02:06] (current) – [CONNECT (4th generation)] neds
@@ Line 1: / Line 1: @@
-====== HDHomeRun CONNECT (4th generation) ======
+====== HDHomeRun CONNECT =====
-{{ :connect4.jpg?direct&200|HDHomeRun CONNECT (4th gen) - Front}}
+<lead>The HDHomeRun CONNECT was the name given to two generations of over-the-air HDHomeRun products, the HDHR4 and HDHR5.</lead> Information on this page generally applies to both generations, unless specifically noted.
-{{ :connect4_2.jpg?direct&200|HDHomeRun CONNECT (4th gen) - Back}}
-^ Model numbers  ^ Signal type  ^
-| HDHR4-2US     | <wrapper>8-VSB/ATSC \\
-QAM64/256</wrapper> |
-| HDHR4-2DT     | DVB-T/T2 |
-| HDHR4-2IS     | ISDB-T |
-^ Tuners | 2 |
+===== CONNECT 4K =====
-^ Works with DVR | Yes |
+<WRAP indent>
-^ Size |  |
+The HDHomeRun CONNECT 4K is the first HDHomeRun ATSC 3.0 model from Silicondust, built on the platform of the fifth generation CONNECT. The "4K" model is specific to North America's ATSC market, primarily aimed at the United States and their recent launch of ATSC 3.0, which supports up to 4K resolution content. It is similar in feature set to the CONNECT QUATRO, but instead of having four ATSC 1.0 tuners, it has two tuners that can do either ATSC 3.0 or 1.0, and then two tuners that are ATSC 1.0-only.
-^ Ports | Power, Ethernet (100baseTX), Antenna |
-^ Power supply | <wrapper>5V 1A regulated power adapter (higher A rating ok) \\
-.1mm ID / 5.5mm OD plug, 9-10mm depth, center positive \\
-Max 5.25V @ no-load \\
-Min 4.75V @ 1A \\
-Noise <= 100mVp-p</wrapper> |
-<WRAP clear/>
+For information and help with ATSC 3.0, please see our page on **[[ATSC 3.0]]**
-===== FAQ and LED status =====
+<WRAP box>
-<btn type="success" size="xs" icon="fa fa-chevron-right">[[:FAQ|See also: other FAQ listings]]</btn>
+^ ^ Model numbers  ^ Tuners ^ Signal type ^
-==== Leftmost LED on HDHomeRun is blinking green ====
+| CONNECT 4K | HDHR5-4K | 4 | Both ATSC 3.0 and 1.0 are supported on 2 tuners \\ ATSC 1.0-only is supported on the other 2 tuners \\ (all tuners also support QAM64/256) |
-This indicates that the HDHomeRun has a network connection but is not getting an IP address from your router. Check to make sure that the DHCP function is enabled on your router, and that either the allowed devices/access control/MAC filtering function on the router is disabled, or that the HDHomeRun is on the allowed list.
+^ Works with HDHomeRun [[:DVR]]  | Yes                                                                                                                                                                                                                                                                                                                                                                        |
+^ Size            | 3.4"x3.4"x0.8"                                                                                                                                                                                                                                                                                                                                                             |
+^ Ports           | Antenna, Ethernet (100baseTX), Power                                                                                                                                                                                                                                                                                                                                       |
+^ Power supply    | <wrapper>  5Volt 1.5Amp regulated power adapter (higher Amp rating ok) \\  1.7mm ID / 4.0mm OD plug, 9.5mm depth, center positive \\  Max 5.25V @ no-load \\  Min 4.75V @ 1.5A \\  Noise <= 150mVp-p </wrapper>  |
+</WRAP>
+</WRAP>
+===== CONNECT DUO & QUATRO (5th generation) =====
+<WRAP indent>
-==== Leftmost LED on HDHomeRun is solid red ====
+The HDHomeRun CONNECT DUO and HDHomeRun CONNECT QUATRO are 5th generation HDHomeRun network tuners.
-This indicates that the HDHomeRun does not have a network connection. Please try a different network cable and port on your switch/router. If the issue persists, please open a **[[:trouble ticket]]**.
+<WRAP box>
+^ ^ Model numbers  ^ Tuners ^ Signal type ^
+| CONNECT DUO | HDHR5-2US | 2 | 8-VSB/ATSC & QAM64/256 |
+| ::: | HDHR5-2DT | 2 | DVB-T/T2 & DVB-C |
+| CONNECT QUATRO | HDHR5-4US | 4 | 8-VSB/ATSC & QAM64/256 |
+| ::: | HDHR5-4DT | 4 | DVB-T/T2 & DVB-C |
+^ Works with HDHomeRun [[:DVR]]  | Yes                                                                                                                                                                                                                                                                                                                                                                        |
+^ Size            | 3.4"x3.4"x0.8"                                                                                                                                                                                                                                                                                                                                                             |
+^ Ports           | Antenna, Ethernet (100baseTX), Power                                                                                                                                                                                                                                                                                                                                       |
+^ Power supply    | <wrapper>  5Volt 1.5Amp regulated power adapter (higher Amp rating ok) \\  1.7mm ID / 4.0mm OD plug, 9.5mm depth, center positive \\  Max 5.25V @ no-load \\  Min 4.75V @ 1.5A \\ Noise <= 150mVp-p </wrapper>  |
+</WRAP>
-==== No/few channels found in channel scan ====
+</WRAP>
-<wrap indent>**See also: [[Troubleshooting]]**</wrap>
+===== CONNECT (4th generation) =====
+<WRAP indent>
-If you are using cable, verify that unencrypted digital channels are present on the line you are using. Many larger cable providers, including Comcast, RCN, TWC, Charter, Brighthouse, and Cablevision, have begun encrypting all channels they carry. HDHomeRun CONNECT would not be usable with these providers – you would need to utilize an antenna in order to receive over the air broadcasts (if available), or instead use HDHomeRun PRIME along with a CableCARD from the provider.
+<WRAP box>
+^ Model numbers  ^ Signal type  ^
-If you are using an antenna, verify that signals are present on the same cable using another device, if possible. If you have an amplifier on the line, try removing it in order to make sure that you are not overloading the tuners.
+| HDHR4-2US     | 8-VSB/ATSC & QAM64/256 |
+| HDHR4-2DT     | DVB-T/T2 |
-If you are using the HDHR-EU, HDHR3-EU, or HDHR3-4DC with a DVB-C signal source, verify that you have the correct modulation settings entered on the DVB-C tab in HDHomeRun Setup.
+| HDHR4-2IS     | ISDB-T |
-If you need further assistance, please open a support ticket:
-  - Go into the Advanced tab in HDHomeRun Setup, and check the Send diagnostic information to SiliconDust support box
+^ Tuners          | 2                                                                                                                                                                                                                                                                                                                                                                    |
-  - Unplug the power cord from the HDHomeRun, count to ten, and plug it back in
+^ Works with HDHomeRun [[:DVR]]  | Yes                                                                                                                                                                                                                                                                                                                                                                  |
-  - On the Digital Cable or Digital Antenna tab (whichever is appropriate), run a channel scan
+^ Size            |                                                                                                                                                                                                                                                                                                                                                                      |
-  - Open a **[[:support ticket]]**. Make sure to include the 8 digit device ID for your HDHomeRun so our support personnel can review your diagnostic data. Note that you do not need to send any files, all information is sent automatically once the box is checked.
+^ Ports           | Antenna, Ethernet (100baseTX), Power                                                                                                                                                                                                                                                                                                                                 |
+^ Power supply    | <wrapper>  5Volt 1Amp regulated power adapter (higher Amp rating ok) \\  2.1mm ID / 5.5mm OD plug, 9-10mm depth, center positive \\  Max 5.25V @ no-load \\  Min 4.75V @ 1A \\  Noise <= 100mVp-p </wrapper>  |
+</WRAP>
-{{tag>connect4 hardware}}
+</WRAP>